Windshield Repair Articles
12-22-2011 - January 2012
12-23-2011 - Merry Christmas from Delta Kits!
11-22-2011 - December 2011
10-31-2011 - November 2011
09-29-2011 - October 2011
07-25-2011 - August 2011
08-31-2011 - September 2011
04-28-2011 - May 2011
05-27-2011 - June 2011
06-23-2011 - July 2011
03-31-2011 - April 2011
02-25-2011 - March 2011
01-25-2011 - February 2011
12-30-2010 - January 2011
11-29-2010 - December 2010
10-29-2010 - November 2010
10-01-2010 - October 2010
08-31-2010 - September 2010
07-31-2010 - August 2010
06-30-2010 - July 2010
05-31-2010 - June 2010
05-01-2010 - May 2010 Issue
03-31-2010 - April 2010 Issue
03-01-2010 - March 2010 Issue
01-31-2010 - February 2010 Issue
01-03-2010 - January 2010 Issue
12-01-2009 - December 2009 Issue
11-01-2009 - November 2009 Issue
09-30-2009 - October 2009 Issue
09-01-2009 - September 2009 Issue
07-31-2009 - August 2009 Issue
07-01-2009 - July 2009 Issue
06-01-2009 - June 2009 Issue
05-01-2009 - May 2009 Issue
04-01-2009 - April 2009 Issue
03-02-2009 - March 2009 Issue
02-01-2009 - February 2009 Issue
01-01-2009 - January 2009 Issue
11-25-2008 - December 2008 Issue
11-27-2007 - November-December 2007 Issue
Wise Crack Past Archives
The Wise Crack
Windshield Repair Newsletter
The Wise Crack, published monthly, is the most widely circulated windshield repair newsletter available! It includes windshield repair tips, news, & marketing advice.
Delta Kits Customer Speaks Out!
Saturday, July 31, 2010
Delta Kits Dear Korey,
I ordered the premium pit resin #144-14, 7 ml on 7-19-2010. I used it on 7-21-2010 on an 18 wheeler windshield. I noticed it took less to seal the break and had fewer shavings. The heat on the east coast has been near 100F degrees daily for 2 months. I was using pit premium 144-2 prior to this. With the high heat this resin liquefied fast and would run down the windshield, prior to getting the square over it, or would slide downward. The new pit resin stays put and I seem to use less of it, to seal the break. I have used this resin since that date on 13 breaks ranging in size from ¼ inch to 2 inches and about 6 chips, mostly big rigs. The results were fantastic and I no longer have the run problem or excessive air bubbles. If you are working in the extreme heat, I highly recommend a test trial of this product. I paid a few dollars extra for the product, however I am using less of the pit resin, which should save me money over the long run.
Thanks Brent for recommending it on one of your July post.
Cordially, DB
Author: DB
09-03-2010



